Michigan Sportsman Forum banner
1 - 9 of 9 Posts

· Registered
Joined
·
1,054 Posts
Discussion Starter · #1 ·
I have a 1996 Polaris XCR600 that I am looking to trade for an aluminum Deep V with motor and trailer.

The sled is worth near 2k, and looking for a boat in the same range, even swap.

the sled has a new track, good drive belt, extra plugs, carbs have been tuned, SLP Ultra skis, a bit of suspension work, w/s bag, LOTS of clutch work, new springs, weights, triple helix and new buttons last year, will also throw in a spare chasis... can never have enough spare parts

The boat I am looking for will be used as a tender rig for the layout boat I plan on building, so frills like pedestal seats and trolling motors are not necessary!

:D

Thanks!

Chip
 

· Registered
Joined
·
98 Posts
Yo Chip,
Give me a shout when you get a chance. I just happen to have a 18' Crestliner with trailer and 65 hp Merc with power tilt. I began working on this boat this summer. Stripped out the wood seats (left the alum frames), removed the old foam and cleaned it up. The motor has had a new computer installed but I haven't run it since I had the mechanic install the motor for me. The boat will need some work. If you're interested, give me a shout. I'm figuring on merely covering it for the winter and selling it come spring. It's the one we used as a tender for a while in our guide service. I pulled the 50 off it and put the 65 on it.
Later partner,
Lou
 

· Registered
Joined
·
98 Posts
Here's some pics...assuming they load properly. If not, they're on "my photos" or I'll email them to you. There's also a bit I wrote on the boats in "my photos".
I've got $1500 into it and would like to get that out. There's also some work required before it can "hit the water".
Lou





 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top