Michigan Sportsman Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
5,024 Posts
Discussion Starter · #1 ·
I'm looking for some plans/drawings to make rod trees to. I have 2' dia. aluminium tubing. Any help would be appreciated.
Height -
length of holders -
angle of holders -
 

·
Registered
Joined
·
5,024 Posts
Discussion Starter · #3 ·

·
Registered
Joined
·
318 Posts
Should probably mention the hole saw part was challenging. A drill with clutch is a must and a few pilot bits.
A saw the same diameter as your pipe then cut in till the back of the hole saw just touches your main. Just the way you want your pipe to sit. I believe I drilled my pilot first. Good luck. Post a pic
 
1 - 4 of 4 Posts
Top