Probably burn't something out in the main control board. You can buy a new board for 20.00 off e bay or thru Minn Knota for around 160-170. Easy to put in as it just plugs in.
Power drive V2 stuck on high
Was fishing with my youngest today and he says from the back of the boat, “somethings sizzling back here”. Long story short, chasing a bass in shallow and the prop wound itself with weeds. Turned off the power, cleared the weeds and now the motor has one speed, fast!!! Does not have a foot pedal just the co pilot key fob and cycles (with beeps) through the allotted designated speeds but doesn’t change speed, make sense? Is there a reset in the motor? I looked at a bunch of YouTube videos but I can’t find anything pertaining to this exact problem.
Thanks Jason
Thanks Jason
1 - 2 of 7 Posts
I just replaced one after talking toMinn Kota in GR. Remove both side covers amd snap out the middle piece. The cont rol board is under tht and all you have to do is remove 2 or 3 screws that hold board in place. The unplug the wire and plug them into the new board. Then put back together. He old me that any power drive uses the same board as long as i not auto pilot. You can change the older ones over the same way but you have to change the foot pedal as it changes from flat plug to a round one
1 - 2 of 7 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Michigan Sportsman Forum
A forum community dedicated to hunting and fishing enthusiasts in the Michigan area. Come join the discussion about safety, gear, tackle, tips, tricks, optics, hunting, gunsmithing, reviews, reports, accessories, classifieds, and more!
Full Forum Listing
Recommended Communities
Join now to ask and comment!
