My shanty has a 2x2 ft hole I can use. I drill (6) 10in holes with my power auger, then spud out in between the holes(usually about 1-2in) and lift out the ice block.
Holes for spearing
Question. What is the best way to drill / cut holes for perch spearing? How big should the hole be?
Thanx in advance.
Thanx in advance.
1 - 3 of 3 Posts
We Just Use A Chain Saw, With A 24" Bar. Make Sure The Oil Is Run Out Of The Machine Before Using On The Ice. The Water Becomes Your Lubercant For The Chain. We Cut A Hole 2' Wide x 6 to 8' Long. Then We Use The Old Fasion Ice Tongs To Pull The Blocks Of Ice Out.
1 - 3 of 3 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Michigan Sportsman Forum
A forum community dedicated to hunting and fishing enthusiasts in the Michigan area. Come join the discussion about safety, gear, tackle, tips, tricks, optics, hunting, gunsmithing, reviews, reports, accessories, classifieds, and more!
Full Forum Listing
Recommended Communities
Join now to ask and comment!
