Michigan Sportsman Forum banner

1 - 1 of 1 Posts

·
Banned
Joined
·
3,397 Posts
Discussion Starter · #1 ·
I have a 79 Yamaha Enticer 250 that I purchased for the intentions on ice fishing. Always stored inside!!! I swapped the original carburetor out with a mikuni for reliability reasons. I bought the sled for 350 and put a few hundred into it getting it to where it is now. New windshield, new belt, runners(hyfax), and the carburetor and all the parts for tuning it. Included will be a box with the original carb and throttle cable, the oil pump which I did not remove, the previous owner did, 2 new plugs for it, a new primary and secondary spring, which I replaced the old ones last winter and purchased extras seeing as they are starting to get hard to get a hold of, you will have a set! The air box, and some random bolts and other parts that came off the sled during the swap. I also have some shims for the primary spring. I was going to try to raise the engagement on the primary, so I had my buddy make those shims. They are in a pic on the seat of the machine, next to the new plugs. I have not tried to fit them yet or anything, but if the machine goes, I have no use for them so I am including them. I installed a tunnel-mounted hitch for pulling a shanty too. This machine runs very good and is tuned for winter! Would make a great ice fishing sled, or for a young guy just learning..
(810) 240-1886 I am asking 300 FIRM for this machine. I would like to see it gone ASAP, though.

See Craigslist ad for more pics: http://flint.craigslist.org/rvs/3172340799.html - See More Here: http://www.michigan-sportsman.com/classifieds/showproduct.php?product=23657
 
1 - 1 of 1 Posts
Top