Best break action and where to buy?

Discussion in 'Air Guns' started by shell waster, Jul 8, 2018.

  1. garyrodbender

    garyrodbender

    Messages:
    3,670
    Likes Received:
    3,094
    Location:
    1/2 way between Higgins & Torch
    I`m thinking about getting a Hatsan Edge 22 cal combo...
    Anyone have one they care to review for me ?
    Thanks .
     
  2. Woodsman27

    Woodsman27

    Messages:
    207
    Likes Received:
    135
    Location:
    Traverse City, MI
     

  3. garyrodbender

    garyrodbender

    Messages:
    3,670
    Likes Received:
    3,094
    Location:
    1/2 way between Higgins & Torch
    Thanks, I did watch that video earlier today.
    Went to Jays and came home with one.
    30 yards out and it shoots pretty good for a new gun.
    Actually had (4) 3 shot groups that were all touching out of the 40 or so pellets shot. And that was with the open sites ;)
    I kept moving the dial to bring my shots down as I was shooting high...Again only with open sites.
    Mounted the 3-9 scope and focused it.
    Tomorrow I will try dialing it in . Not bad for the cost.
    Quite pleased with it so far.
     
    Petronius likes this.
  4. garyrodbender

    garyrodbender

    Messages:
    3,670
    Likes Received:
    3,094
    Location:
    1/2 way between Higgins & Torch
    Well got a chance to zero the scope , and to my surprise was shooting some good groups ...25 , 30 35 yards out. 5 shot groups were all minute of squirrel or chipmunk ;) actually they were 1/2" to .75" . Beyond 40 yards with the
    Benjamin Discovery .22 Cal, 14.3 Grains, Hollowpoint,
    they started to spread out to much .
    So with the gun and ammo used so far, I think this will be a great tool for in and around the house for our PEST control

    Gun/combo ,
    https://www.pyramydair.com/images/PY-3079_Hatsan-Striker-Edge-Air_1463160747.jpg
     
  5. slowpoke

    slowpoke

    Messages:
    5,560
    Likes Received:
    229
    Location:
    Davison,Mi.
    So can I sell a RWS 54 on this sight now because it's not a firearm.
     
    tincanary likes this.
  6. Petronius

    Petronius Premium Member

    Messages:
    29,798
    Likes Received:
    22,067
    Location:
    Michigan
    I am not sure. Send a PM to Steve and ask him.
     
  7. tincanary

    tincanary

    Messages:
    3,693
    Likes Received:
    6,700
    Location:
    Warren
    Never use a metal bore brush on an air rifle, the steel is much softer than that of a powder burner. You will damage the rifling which will make the gun inaccurate. The best way to clean an air rifle barrel is to use a small diameter wooden dowel or weed whacker string and a bore patch soaked in Goo Gone. Run the patches through until they come out clean.