BilgeRat
12-04-2004, 08:10 PM
I need some advice on whether or not to put in vents. I am just about done with building a portable shanty. Got plans from LineStretcher(many thanks to him). Shanty is 6 ft tall, 7 ft long, 44 inches wide. The 2 ends are 3/8 plywood. The covering is a heavy black/silver tarp from west marine.
These are the 2 items I will be using in the shanty for heat and light:
Heater : Mr Buddy portable heater
Lantern: coleman northstar propane
I am concerned about the gases from these units.
Should I put in VENTS?
If so, I am thinking of putting in a 3"x5" vent on each end about 14 inches above the door and to the left. Is this a big enough vent hole?
Please help me.
By the way, got super deal on the Mr. Buddy from Gander Mountain. They sell them for $79.99. Here is the deal:
They matched TSC price of 69.63, then they subtracted the difference from the 69.63. My cost w/tax was around $59 and change.
I did the same for the lantern.
They will do this for any competitor item but you have to ask them!
These are the 2 items I will be using in the shanty for heat and light:
Heater : Mr Buddy portable heater
Lantern: coleman northstar propane
I am concerned about the gases from these units.
Should I put in VENTS?
If so, I am thinking of putting in a 3"x5" vent on each end about 14 inches above the door and to the left. Is this a big enough vent hole?
Please help me.
By the way, got super deal on the Mr. Buddy from Gander Mountain. They sell them for $79.99. Here is the deal:
They matched TSC price of 69.63, then they subtracted the difference from the 69.63. My cost w/tax was around $59 and change.
I did the same for the lantern.
They will do this for any competitor item but you have to ask them!