PDA

View Full Version : reloading



hunterdau2
07-15-2009, 10:45 AM
Looking for a source of powder in the Bay City area. Any gunshops or supplier's in the area?



Rustyaxecamp
07-15-2009, 10:49 AM
Good luck. Driving to Jays is going to be your best bet. I was there this weekend, very decent supply. What are you looking for?
3fingervic
07-15-2009, 01:11 PM
Isn't there a place to buy powder in Saginaw?
QuakrTrakr
07-15-2009, 01:33 PM
Franks in Linwood usually has some. They don't have the biggest selection, but most of the common powders.

Erik, did you look at the die selection there? The last few times I've been there, the shelves were getting pretty bare. Especially in the pistol calibers.
Rustyaxecamp
07-15-2009, 02:20 PM
I did. Little pistol calibers dies. Even the rifle gear is getting picked over.

I've had a set of 38/357 dies on backorder from Midway for 2 months....... Their website says they expect them in 7/20/09. We will see.
Rustyaxecamp
07-15-2009, 02:23 PM
Isn't there a place to buy powder in Saginaw?

Dick Williams usually has a limited supply. Gander usually has little to none. Not sure of Duncans in Bay City.

Williams in Auburn usually has some of the common flavors in stock.
hunterdau2
07-15-2009, 04:40 PM
Looking for 4lb jug of E3! May have to go to Port Huron to find it, was hoping to get it in BC since i'll be there tomorrow.