How would you add a trim switch on the transom??

[waterfoul]

Got the trim on the throttle and at the bow. How would you wire in a switch at the transom? I have a mom-on/off/mom-on switch right here in my hand and am wondering how to wire it into the system. This switch has 3 leads on the back of it. Sure would make putting the transom saver on at the ramp.

[Damark Marine]

You didnt mention what kind of rig you have, give me a little more info, make model ect. I can help you figure it out pretty simple.

[waterfoul]

88 Tracker Pro 17, 40 hp Mariner. The motor actually only has Tilt... no trim. So it seems it should be pretty easy but I'd like a little advice before I go cutting any wires!!

[Mitch]

I'm curious to see an answer to this question if there is somebody out there with one. I'd like to add a momentary switch at the bow for my anchor winch.

Mitch

[FishTales]

Mike,
I think if you check the switch in front, you will see what wires you need to use.
I did find a site that had the color codes for the wires and it was the same as I said in the pm.
The red wire went from the switch into a harness, don't know where it went without taking something apart to trace it, but it has to be a hot lead.
If you need any more pic's, let me know. :)
Rich